CC2642R-Q1: To import IAR project to CCS

Isao Takigasaki

Part Number: CC2642R-Q1
Other Parts Discussed in Thread: SIMPLELINK-CC13X2-26X2-SDK

I found the following thread.

e2e.ti.com/.../170231

This thread explains that slau157s.pdf describes the method to import an IAR project to CCS, but the documentation is not found.
Could you explain how to import IAR project to CCS or provide any related documentation?

Best Regards, Taki

over 3 years ago

0 Ryan Brown1 over 3 years ago

TI__Guru**** 202096 points

Hi Taki,

Here is the SLAU157 documentation that was referenced by the other thread, however it will not be of any assistance for the SIMPLELINK-CC13X2-26X2-SDK and SimpleLink platform. The best way to migrate is to import a new project from the desired IDE and transfer your changes and application code over to the new example. This is also referenced in the BLE5-Stack Migration Guide.

Regards,
Ryan

0 Isao Takigasaki over 3 years ago in reply to Ryan Brown1

TI__Intellectual 2490 points

Hi Ryan-san
Thank you for your answer.

I see. An additional effort is needed before to start the development on CCS based on a given project for SIMPLELINK device on IAR.

So, in this case, - this is my customer's case - I think that it's easy for the customer to open the given project on IAR as an IDE for SIMPLELINK with using SIMPLELINK SDK for IAR, to develop their software based on the given project.
Am I right?

Best Regards, Taki

0 Ryan Brown1 over 3 years ago in reply to Isao Takigasaki

TI__Guru**** 202096 points

The SDK is supported in IAR as well, you can check the recommended version in the Release Notes and setup in the Quick Start Guide.

Regards,
Ryan

Bluetooth®︎

Bluetooth forum

CC2642R-Q1: To import IAR project to CCS