Example code for programming CC2650 ADC on CM3

Zaffer Merchant

Other Parts Discussed in Thread: CC2650

Having some trouble programming the CC2650 ADC from the CM3 (not Sensor Controller). Does anyone have a any example code or prototype functions or point me to a good resource?

Thanks, Zaffer

over 10 years ago

0 svendbt over 10 years ago

TI__Mastermind 29650 points

Hi Zaffer,

I wrote a small example here that might help you on the way:
e2e.ti.com/.../1433112

We also have some new low-level functions to do ADC measurements included in driverLib which is a part of the new TI RTOS released yesterday.
However, the TI RTOS ADC driver (which will handle DMA, power management etc) will not be available until June.

Regards,
Svend

0 Zaffer Merchant over 10 years ago in reply to svendbt

Intellectual 515 points

Thanks Svend - will give your ex. program a try!
Is the new RTOS available on the website?

Thanks, Zaffer

0 svendbt over 10 years ago in reply to Zaffer Merchant

TI__Mastermind 29650 points

Yes. There is a sticky post on the top of the Bluetooth LE forum with details: e2e.ti.com/.../538

Regards,
Svend

0 Zaffer Merchant over 10 years ago in reply to svendbt

Intellectual 515 points

Gracias Amigo

0 Nick Tompkins over 10 years ago in reply to Zaffer Merchant

Intellectual 445 points

Is the new RTOS Driver out yet?

0 Allen Jameson over 10 years ago in reply to Nick Tompkins

Intellectual 370 points

I have the same question, is the RTOS ADC driver released yet? I have not seen an answer to this in the forum, and from the SDG / TRM it looks like this is not implemented yet.

ETA?

Bluetooth®︎

Bluetooth forum

Example code for programming CC2650 ADC on CM3