SMARTRFTM-STUDIO: How to load TX test software for RF measurements

Patrick COMBETTE

hello

I would like to know if it's poossible, and how to flash the test configuration that run on smart rf studio, in the chip cc2640r2 embedded on my board, and let it run independantly without keeping it connected to smartrfstudio ?

thank's a lot !

Patrick

over 4 years ago

0 TER over 4 years ago

TI__Guru**** 317180 points

This is not possible directly. What you need to do is to use one of the examples provided in the SDK and (optional) export the settings from SmartRF Studio into the example.

See typically the rfCarrierWave and rfPacketTX examples here: http://dev.ti.com/tirex/explore/node?node=APwBWdtqTgxZuJ9l4iRqpQ__krol.2c__LATEST&search=debug and http://dev.ti.com/tirex/explore/node?node=ACaSjssfEGPy9edpCGWykw__krol.2c__LATEST&search=debug

0 Patrick COMBETTE over 4 years ago in reply to TER

Intellectual 755 points

Hello

THank's a lot !

I followed your instructions, and it finally works !

In fact, at first I didn't set the RF Amp settings through RFCore I/Os.....

All is OK now !

Have a nice day.

Patrick

Bluetooth®︎

Bluetooth forum

SMARTRFTM-STUDIO: How to load TX test software for RF measurements