Hi
I would like to run CC2642R1 Boundary Scan Test using "cc13x2_c26x2_bsr.bsdl" BSDL file on Keysight X1149 BSCAN Aanalyzer and In-Circuite tester, but the part doesn't work in BSCAN mode at all. It fails Boundary Scan Infrastructure test.
After read the datasheet, this part needs to be configured from cJTAG to JTAG step first in order to use 4-Pin JTAG port.
Datasheet "cc2642r-q1.pdf" page# 47.
I discovered TI and other sites to find the Technical document regarding to the configuration from cJTAG to JTAG, but couldn't find any doc.
Is there any document which explain this?
Any help is much appreciated!
Thanks.