Our customer plans to use this solution to design a wireless microphone and need apply for certification of FCC ID, RED, SRRC, TELEC ID
So below testing mode is needed:
Hopping (low/middle/high channel), TX, all Data rate
Non Hopping (low/middle/high channel), TX, all Data rate
Non Hopping (low/middle/high channel), RX, all Data rate
Normal operating (hopping) mode (Signaling Mode)
Single carrier TX (low/middle/high channel)
And they need detailed Operation Instruction of RF Testing for Third-party Lab to operate testing.
What hardware does TI have to provide customers with to build this testing platform, and is there an evaluation board suitable for this test?
Are there any current software that can output these RF signals for testing purposes? Is SmartRF studio available?
Is there any relevant guidance document available for customers to refer to?