This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CC2400 timing between state switching

Other Parts Discussed in Thread: CC2400

Hello community,

I am programming highly demanding application from timing perspective using CC2400. I need to change between RX and TX states with minimum delay, i.e., with maximum speed allowed by hardware. My processor runs on 100MHz. I controll CC2400 with RX and TX pins, while on GIO6 I observe FS_LOCK state.

Could anybody provide some info about for example, how much does it take to move from PIN_TX state to PIn FS_ON state and then to BEFORE IDLE state -> IDLE?

Best regards