CC2543: PER test reference code

Swe

Part Number: CC2543

Hello everyone,

I am working with SmartRF05 Evaluation board and cc2543EM. when i am using SmartRF Studio both boards master and remote working well but when i load PER test code which is from TI website then remote showing error no beacon signal found in LCD. Please tell me what will the problem.

over 5 years ago

0 Fredrik K over 5 years ago

TI__Guru** 106705 points

Hi Swe,

You must enable the Master node before starting the Remote node.

Regards,
Fredrik

0 Swe over 5 years ago in reply to Fredrik K

Prodigy 20 points

Hi Fredrik,

ya i am enabled Master before Remote node but getting same error no beacon signal.

actually with pre programmed kit i am able to do PER test but when i am coded with PER code which is downloaded from website then i am getting this error. Is there any changes do in code with timing or any issuses ?Please help me out with this.

Other wireless

Other wireless technologies forum

CC2543: PER test reference code