CC2500: cc2500

shay ron

Part Number: CC2500
Other Parts Discussed in Thread: CC2530

Hello I wonder in device cc2500 in order to get continuous random tx mode beside of the registers configuration what operation should be done by the firmware

to get this mode?

shay ron eilon engineering israel

over 2 years ago

0 Ryan Brown1 over 2 years ago

TI__Guru**** 202216 points

Hi shay,

Are you using SIMPLICITI, CC2500 Basic RF examples, or Smart RF Studio 7? Random TX mode is selected through the PKT_FORMAT bits of the PKTCTRL0 register, as shown in the datasheet.

Regards,
Ryan

0 shay ron over 2 years ago in reply to Ryan Brown1

Prodigy 10 points

Hi Ryan Ian using the smart rf studio with an evaluation board which work fine but i dont knoe if there is any strobe commands to execute in addition to the registers settings

regards cshay

0 Ryan Brown1 over 2 years ago in reply to shay ron

TI__Guru**** 202216 points

You can review the Smart RF Studio Help Documentation and CC2530 Datasheet for further information regarding capabilities. This Application Report may also be relevant to your interests.

Regards,
Ryan

0 shay ron over 2 years ago in reply to Ryan Brown1

Prodigy 10 points

Hi i am sorry none of the above is helping me

0 Ryan Brown1 over 2 years ago in reply to shay ron

TI__Guru**** 202216 points

What specifically are you seeking assistance in accomplishing?

Regards,
Ryan

Other wireless

Other wireless technologies forum

CC2500: cc2500