CC1101: The way to know the IF and LO frequency on CC1101

This is the 3rd question today about this, please coordinate.

See e2e.ti.com/.../cc1101-if-and-lo-frequency-for-ul-etsi-en-300-220-1-v3-11

Hello TER-san,

I apologize for the duplicated post.
But we couldn't see the page you attached.

Best Regards,
Nomo

Which exact link is not working? 

For old post I poited to:

"CC1101 uses low side LO injection. The receiver LO frequency (f_LO) is below the carrier frequency (fc). The received carrier fc and f_LO are mixed and downconverted to IF (intermediate frequency). If the receiver topology does not have image rejection. a signal which is IF below the receiver LO frequency (i.e at f_image =  f_LO - IF = fc - 2 x IF) will be received just as well as the wanted signal at f_c. "

Hello TER-san,

Thank you for your comment.

The link is following.
e2e.ti.com/.../cc1101-if-and-lo-frequency-for-ul-etsi-en-300-220-1-v3-11

Best Regards,
Nomo

Hello TER-san,

Thank you for your comment.
If we had additional question for this, we'll create another thread.

Best Regards,
Nomo