Hi
I am trying to read the LIGHT SENSOR data from CC1350STK using Sensor Controller but the variable I2C_status shows 1 always and the output is zero always. The execution code is as follows:
SCL = DIO6
SDA = DIO5
SCL frequency = 400 kHz
SCL stretch timeout = 10us
U16 value = 0;
//Partial write operation to set address of slave register from which the data has to be read. Slave address = 0X45. Left shifted slave address = 1000101 << 1 = 0001011 = A. Slave register address to read data from = 0X00.
i2cStart();
i2cTx(0xA | I2C_OP_WRITE);
i2cTx(0x00);
i2cStop();
fwDelayUs(100000, FW_DELAY_RANGE_100_MS);
// If successful ...
if (state.i2cStatus == 0x0000) {
// Read register values
i2cRepeatedStart();
i2cTx(0xA | I2C_OP_READ);
i2cRxNack(value);
}
i2cStop();
output.lux = value;
if(value > 500){
state.threshold = 1;
fwGenAlertInterrupt();
}
// Schedule the next execution
fwScheduleTask(1);
It would be highly appreciated if anyone can provide help regarding the same.
Thanks
