LAUNCHXL-CC1352P: Printed Antenna on LAUNCHXL-CC1352P

Hi,

You can have a look at that document: https://www.ti.com/lit/an/swra496a/swra496a.pdf

I think you are looking for Antenna #9.

Regards,

Arthur

Hi dear Arthur R,

Thank you very much for your support. However, I believe this is not the same as the Launchpad CC1352P1. It must be as below:

In the design files, I found the used PCB antenna like this but without dimensions, and the board is labeled "CC-Antenna-DK," not "CC-Antenna-DK2."

Thank you again for taking the time to assist me.

best Regards

Note that the length of the antenna is very board specific meaning that if you want to use this on your own board you have to adjust the length and tune the antenna as described in the DK documentation. If you need the exact dimensions, one suggestion is to open the launchpad design files and measure. 

Dear TheGhostOf,

Thank for your Answer!

But how can i measure from Design Files? Because there is not Dimension given in the Design Files and i don't think it is possible to measure from PDF File :) !

Best regards

Thank you again for taking the time to assist me, 

With the Gerber File is not possible to measure the exact Size but with the Cadence File yes. Now i should look for a free Cadence Viewer

But i got my Solution !