Hello E2E,
I’m trying to change between a few different modes while using Smart RF. I can get all of my modes working except for one:
905Mhz, GFSK, 9.6KBaud, Dev = 4.76KHz Chnl spcng=200Khz, RX fltr BW = 58.03Khz whitena, opt=sens +10dBm
Here’s the register output from SmartRF. During initialization, I’ve set all of the registers above to the correct value, but communication is only working intermittently. Could someone please give me some advice as to what I’m doing wrong? Also, some clarity as to what the colored registers mean would be nice as well.
Thanks,
Wilson
