Tool/software: TI-RTOS
HI
The engineer hello!!
I want to configure CC1310 for sending and receiving mode, two pieces of wireless module can send and receive data to each other.
Now a receive, one to send, normal communication
Can have example reference?
Hi
please take a look at the rfPacketRX and rfPacket TX example in the simplelink_cc13x0_sdk:
Please note that the RX example stays in RX continously. If you want to go to TX from RX, you should set both repeat modes to 0 or remember to cancel the RX command before sending the TX command.
BR
Siri
