CC1350: CC1350 INTERRUPT

vikas kumar24

Part Number: CC1350

Hello all,

I want to use interrupt. I have never used before. My requirement is whenever uart should raise a byte by byte interrupt. Please guide me the some basic code that demonstrate how to use interrupt.

Thanks & regards

Vikas

over 7 years ago

0 YiKai Chen over 7 years ago

Guru 735695 points

I suppose you can use UART RX callback to do single byte receiving. You can refer to e2e.ti.com/.../7801.uartecho.c

0 vikas kumar24 over 7 years ago in reply to YiKai Chen

Expert 1450 points

Hello Yikai,
Thanks for your input. I want to learn how to use interrupts for cc1350. Can u give me some basic guidance , How should i start.

0 TER over 7 years ago in reply to vikas kumar24

TI__Guru**** 317180 points

In a TI-RTOS context?

0 vikas kumar24 over 7 years ago in reply to TER

Expert 1450 points

yes, in TI-RTOS context i want to proceed.

0 TER over 7 years ago in reply to vikas kumar24

TI__Guru**** 317180 points

Have you gone through training.ti.com/ti-rtos-workshop-series to understand HWI and SWI?

0 vikas kumar24 over 7 years ago in reply to TER

Expert 1450 points

No, Till now not. i will complete it by tommorrow. Then what to refer.

Sub-1 GHz

Sub-1 GHz forum

CC1350: CC1350 INTERRUPT