CC1310: Sensor Controller Studio 2.3.0.684 Code Generator Problem

user5774802

Part Number: CC1310

Dear Sir or Madam :

When I use Code Generator of SCS 2.3.0.684 ,it shows line 8 syntax error or unkown identifiers. The detail about the problem see the pictures below. How to do with the problem?

Thanks a lot!

over 5 years ago

0 TER over 5 years ago

TI__Guru**** 317180 points

You are not showing which task resources you have set up.
- Have you defined the pin you want a trigger on?
- Have you allowed to trigger on GPIO?
etc

0 user5774802 over 5 years ago in reply to TER

Intellectual 550 points

The task resource is the example on the SCS "ADC Window Monitor". I'm studying Sensor Controller Fundamental ---Bonus Task 2: GPIO Event Handler

I put the initial code below in the initialization code

output.bvWindowState = 0;

evhSetupGpioTrigger(0, AUXIO_I_GPIO_IN, 1, EVH_GPIO_TRIG_ON_MATCH);

0 TER over 5 years ago in reply to user5774802

TI__Guru**** 317180 points

You have not set up the pin as described in the training.

The reason you get a syntax error is that the line evhSetupGpioTrigger(0, AUXIO_I_GPIO_IN, 1, EVH_GPIO_TRIG_ON_MATCH); expects you to have a digital pin called GPIO_IN but you have an analog pin with a different name. Remove the analog pin and add the digital one as described and you should be able to run.

0 user5774802 over 5 years ago in reply to TER

Intellectual 550 points

Thank you,the issue is solved.

Sub-1 GHz

Sub-1 GHz forum

CC1310: Sensor Controller Studio 2.3.0.684 Code Generator Problem