This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
CC1352P: Generate tracking request whenever required in collector in TI 15.4 stack
Part Number: CC1352P
i just wants to know some parameters descriptions, for hat purpose they used in coding.
1) Polling message
2) Reporting interval
4) Tracking message
5) Association concept
6) Broadcast message
can collector and sensor can communicate without all parameter, which parameters are mandatory and which we can remove?
how it depends on each other?
If my post answers your question, please click on "This Resolved my issue" button to benefit others who have the same issue.
Example to combine rfWakeOnRadioRx into rfWakeOnRadioTx to do TX/RX in the same WOR project.
How to create micro second delay on CC2652R
How to check APS ack in TI Z-Stack
How to detect button hold in CC26x2, CC13x0, CC13x2 SDK.
660 Zigbee devices in the same Zigbee network!
How to setup Mosquitto on Raspberry Pi and make Contiki/Contiki-NG cc26xx-web-demo do mqtt publish to it.
How to connect Contiki-NG cc26xx-web-demo to IBM Watson IoT Platform
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to YiKai Chen:
already tried before saying you, i studied beacon, Non beacon, FH mode.
i implemented in coding also. i am using that polling, tracking, broadcast messages.
But by that messages i am getting that polling is just to check whether data is for me(sensor) or not.
Tracking from collector side just to know that is that sensor is in my network or not.
Broadcast message is for sending a hopping sequence to sensor to hop on that particular channel only.
Config message is for telling to sensor that polling and reporting interval.
Association message is for allowing joining to sensor or not.
But i need more clarity in this message, how can i manipulate this messages and all.
that's why i kept message, i am also not a blindly keeping messages.
In reply to Anil Dhanawade:
To better aid the community, please click on the "This Resolved my issue" button whenever a post answers your question!
In reply to Ryan Brown1:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.