CC3235MODS: LAUNCHCC3235MOD transceiver mode

Jeong Yeol Kim

Part Number: CC3235MODS

I'm using CC3235OMOD in transceiver mode for factory automation application.

I was able to set GPIO mode as 'dynamic' using comon.syscfg at CCS version 10.4.0
But I found no dynamic mode at CCS version 11.1.0.0.11
I need to change input/output mode of a GPIO port at program. How can I do that at CCS 11.1.0.0.11?
Why upgraded CCS doesn't provide dynamic mode of GPIO?

Regards,

J.Y. Kim

over 2 years ago

0 Jesse Baker over 2 years ago

TI__Expert 7830 points

Hi J.Y.,

Please see the GPIO driver API documentation here (for version 6.10.00.05 of the CC32xx SDK): https://dev.ti.com/tirex/content/simplelink_cc32xx_sdk_6_10_00_05/docs/drivers/doxygen/html/_g_p_i_o_8h.html

Specifically, under the Initializing the GPIO Driver section it states:

GPIO_init() must be called before any other GPIO APIs. This function configures each GPIO pin in the user-provided GPIO_PinConfig array according to the defined settings. The user can also reconfigure a pin dynamically after GPIO_init() is called by using the GPIO_setConfig(), and GPIO_setCallback() APIs.

GPIO_init() is called from Board_init() by default. Calling GPIO_init() multiple times is safe.

Best regards,

Jesse

0 Jeong Yeol Kim over 2 years ago in reply to Jesse Baker

Prodigy 130 points

Dear Jesse,

Thanks for the information. I'll follow up on your guide and come back to you if I still have a problem.

Regards,

J.Y.

0 Jeong Yeol Kim over 2 years ago in reply to Jesse Baker

Prodigy 130 points

Hi, Jesse,

Now I understand the whole picture and I don't need to roll back to the older version of CCS.

Thanks.

Regards,

J.Y..

Wi-Fi

Wi-Fi forum

CC3235MODS: LAUNCHCC3235MOD transceiver mode