CC3135MOD: Image Verification methodlogy on Uniflash

Akihiko Fujinaka

Part Number: CC3135MOD
Other Parts Discussed in Thread: UNIFLASH

Hello expert,

Our customer is looking for the procedure to verify the burned image for CC3135MOD is OK on the manufacturing process.

Doe "uniflash" has the function to verify the burned image or get the checksum to verify?

If exists, could you tell me how to run it from the command line interface? Or is there a case where verification process is done automatically by burning the image?

They are reviewing the following materials, but ther are not such description.

If there is any other appropriate material, would you be able to share it?

- User’s Guide UniFlash CC3x20, CC3x3x SimpleLink Wi-Fi® and Internet-on-a chip Solution ImageCreator and Programming Tool
- CC3135MOD Production Line Guide

Regards,

A.Fujinaka

over 2 years ago

0 RogelioD over 2 years ago

TI__Genius 13451 points

Hello Akihiko,

I would refer the customer to the Uniflash Quick Start Guide . In it there is a section in which you can verify the device image.

Kind Regards,

Rogelio

0 Jan D over 2 years ago in reply to RogelioD

Guru 78395 points

Hi,

Unfortunately I am not able write you this message privately, because you not confirmed friendship request.

Quick start guide above is not related to CC31xx devices. At that chapter is described verification via JTAG (e.g. for MCU) but there is no relation to programming via UART loader for CC31xx devices. Programming of image into SPI flash via UART loader works by different way (sending commands via UART and confirmation when device is able extract preprogrammed image).

Jan

Wi-Fi

Wi-Fi forum

CC3135MOD: Image Verification methodlogy on Uniflash