CC3230SF: about power table number

Jerry Kuo

Part Number: CC3230SF
Other Parts Discussed in Thread: UNIFLASH

Tool/software:

Hi team,

My customer said the CC3230 currently supports up to three power tables. They want to clarify if this is still the case, or if there have been any updates to support additional power tables in recent firmware or hardware revisions?

1 month ago

0 Dylan Hubbard 1 month ago

TI__Mastermind 45355 points

Hey Jerry,

There have been no updates to support additional power tables in recent FW/HW revisions.

0 John Hsu 1 month ago in reply to Dylan Hubbard

Prodigy 30 points

Hi Dylan,

One more question about the power table:
Is the power back-off value fixed in the table, or can I adjust it manually?

The reason I’m asking is that if we want to reduce the Tx power on channel 1 and channel 11 to meet the band edge requirements, would it be feasible to do so through power table adjustments?

0 Dylan Hubbard 1 month ago in reply to John Hsu

TI__Mastermind 45355 points

Hey John,

There will be inherent power back-off values that you can't adjust - these are to keep the device compliant with the regulatory bodies we certified too. In cases were you may want to use a higher gain antenna than what we certified with, then yes you can add additional power limits to support that.

To do this you will use Uniflash program and all of the details for how to do this can be found here.

The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.

Wi-Fi

Wi-Fi forum

CC3230SF: about power table number