SIMPLELINK-CC32XX-SDK: SIMPLELINK-CC3200

SUNIL KUMAR1

Part Number: SIMPLELINK-CC32XX-SDK
Other Parts Discussed in Thread: ENERGIA, CC3200, UNIFLASH, CC3100

my cc3200 wifi kit is not being recognized by tera term. energia progrms are running by closing the SOP2 port. but normally it is not working . i tried uniflash after that it is not automatically being recognized at com port . please help also tell how to factroy reset it

over 4 years ago

0 Sarah P over 4 years ago

TI__Mastermind 38980 points

Hi Sunil,

Please see the CC3200 Getting Started Guide. The Configure Board section shows you where to find your COM port in your device manager: http://www.ti.com/lit/swru376

You can also look at the CC3100 & CC3200 UniFlash Guide to learn how to format your CC3200 LaunchPad: processors.wiki.ti.com/.../CC3100_&_CC3200_UniFlash

Best regards,
Sarah

0 SUNIL KUMAR1 over 4 years ago in reply to Sarah P

Prodigy 30 points

i am not able to load firmware again using uniflash 3.4 by reading these steps please elaborate

0 Sarah P over 4 years ago in reply to SUNIL KUMAR1

TI__Mastermind 38980 points

Hi Sunil,

Please explain the issue you are seeing. All instructions for UniFlash are in the user's guide I linked in my previous post.

Be sure you have the jumpers on your LaunchPad configured as shown in the Configure Board section of the Getting Started Guide from my previous post. Plug in you LaunchPad. Then open your computer's device manager to find the COM port.

If you are having trouble running Energia's IDE, please post on their forum for Energia support: forum.43oh.com/.../

Best regards,
Sarah

Wi-Fi

Wi-Fi forum

SIMPLELINK-CC32XX-SDK: SIMPLELINK-CC3200