cc2530: NLME_OrphanJoinRequest Excessive power consumption

Leonardo lemon

Part Number: CC2530
Other Parts Discussed in Thread: Z-STACK

The terminal node loses response and then sends orphan with a high current of approximately 500ms. How to reduce this time?
Or to avoid sending nodes orphan?

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

Do you test Z-Stack? If so, which version are you testing?

0 Leonardo lemon over 8 years ago in reply to YiKai Chen

Prodigy 90 points

Z-Stack Home 1.2.2a.44539

0 YiKai Chen over 8 years ago in reply to Leonardo lemon

Guru 735695 points

If you use Z-Stack 3.0.1, it won't send orphan notification according to Zigbee 3.0 spec.

0 Leonardo lemon over 8 years ago in reply to YiKai Chen

Prodigy 90 points

tank you,i will try.

0 Leonardo lemon over 8 years ago in reply to YiKai Chen

Prodigy 90 points

Very thank you ,I just tried it, it does not send ORPHAN after the coordinator is powered off. But I found that 3.0.1 does not have the compile_flag flag HOLD_AUTO_START. The end device opens NV_RESTORE, and the end device has joined the network before。How to automatically join the network when it is powered on?

0 YiKai Chen over 8 years ago in reply to Leonardo lemon

Guru 735695 points

ZED would start rejoin process after power cycle if you enable NV_RESTORE and it had joined a Zigbee network.

Zigbee & Thread

Zigbee & Thread forum

cc2530: NLME_OrphanJoinRequest Excessive power consumption