RTOS/CC2652R: CC2652R can't debug with XDS100 V3 use CCS 8.10 or IAR for ARM(will blocked in ICall_createRemoteTasks() )

behold li

Expert 2745 points

Part Number: CC2652R
Other Parts Discussed in Thread: UNIFLASH, Z-STACK, , CC2650, LAUNCHXL-CC26X2R1

Tool/software: TI-RTOS newest SDK simplelink_cc26x2_sdk_2_30_00_34

procedure must be blocked in ICall_createRemoteTasks() function every time:

If press 'F5' resume procedure, may be alert:

over 5 years ago

0 Ryan Brown1 over 5 years ago

TI__Guru**** 202106 points

Hi behold,

What specific hardware are you using? Do you encounter any issues when using a different stack or tool (SmartRF Studio 7, Uniflash, etc.)? Can you try using the recommended IDE versions from the Z-Stack/SDK release notes?

Regards,
Ryan

0 behold li over 5 years ago in reply to Ryan Brown1

Expert 2745 points

JTAG Hardware is XDS100 V3.

SmartRF Studio 7, Uniflash work well,only can not debug with CCS 8.1 or IAR for ARM 8.20.2,step over would be blocked in ICall_createRemoteTasks()

0 Ryan Brown1 over 5 years ago in reply to behold li

TI__Guru**** 202106 points

You've mentioned the debugger hardware but I was speaking towards the CC2652R PCB. The SimpleLink CC26X2 SDK 2.30.00.34 Release Notes recommends CCS 8.2 or IAR 8.20.

Regards,
Ryan

0 Ryan Brown1 over 5 years ago in reply to behold li

TI__Guru**** 202106 points

Hi behold,

Were you able to resolve this issue?

Regards,
Ryan

0 behold li over 5 years ago in reply to Ryan Brown1

Expert 2745 points

I will test with new XDS200 instead of XDS100V3 in the near future,there are on the road.

0 behold li over 5 years ago in reply to Ryan Brown1

Expert 2745 points

Hi Ryan,I have been test with XDS200 emulator,it debug on IAR or CCS 8.3 and work well,not blocked in ICall_createRemoteTasks function. I think XDS100 V3 may be not suitable for newest SimpleLink MCU CC26xx(include CC2652R,CC2650 etc.)

0 Ryan Brown1 over 5 years ago in reply to behold li

TI__Guru**** 202106 points

I agree with your assessment behold, it is worth noting that the debugger on-board the LAUNCHXL-CC26X2R1 is a XDS110.

Regards,
Ryan

Zigbee & Thread

Zigbee & Thread forum

RTOS/CC2652R: CC2652R can't debug with XDS100 V3 use CCS 8.10 or IAR for ARM(will blocked in ICall_createRemoteTasks() )