Other Parts Discussed in Thread: CC1352P, SMARTRFTM-STUDIO, SYSCONFIG, Z-STACK
Tool/software: Code Composer Studio
Hi all,
Our setting is showing below :
SW : simplelink_cc13x2_26x2_sdk_3_40_00_02, smartRF Studio 7-2.16.0
HW : CC1352P-2 DK, Customer board(CC2652P)
test :
studio 7 --> set TX power = 20dbm
Spectrum Analyzer --> CC1352P-2 DK --> get 19.x dbm
Customer board(CC2652P) --> get 19.x dbm
simplelink_cc13x2_26x2_sdk_3_40_00_02 --> CC1352P_2_LAUNCHXL --> zstack --> zed_sw
setting tx power :
zstack_sysSetTxPowerReq_t req;
zstack_sysSetTxPowerRsp_t rsp;
req.requestedTxPower = 20;
Zstackapi_sysSetTxPowerReq(appServiceTaskId, &req, &rsp);
Spectrum Analyzer --> CC1352P-2 DK --> get 14.x dbm
Customer board(CC2652P) --> get 3.x dbm
question :
1. Where is the power table in simplelink_cc13x2_26x2_sdk_3_40_00_02 --> zstack ? How to check the power table is correct?(when I change the power with PA in studio, there is no parameters change)
2. When we use CC2652P, do we need change anything in zstack ?