CC2531EMK: AF_DATA_CONFIRM status = 0xF0

Luca Vetri

Part Number: CC2531EMK

Hi,

I've been testing an end-device that is far away from the coordinator. After some time I receive an AF_DATA_CONFIRM with status 0xF0.

Can't really find the definition of that status value.

Any site I can refer to for future references? Already looked at ZCL errors and ZStack one.

Best Regards,

Luca Vetri

over 2 years ago

+1 YiKai Chen over 2 years ago

Guru 735455 points

Try to refer to e2e.ti.com/.../cc2530znp-unknown-status-byte-value-in-af_data_confirm-command

0 Luca Vetri over 2 years ago in reply to YiKai Chen

Intellectual 560 points

Thank you so much.

0 Luca Vetri over 2 years ago in reply to YiKai Chen

Intellectual 560 points

Any way to decrease the pooling time?

+1 Ryan Brown1 over 2 years ago

TI__Guru**** 202106 points

Hi Luca,

0xF0 represents ZMacTransactionExpired and POLL_RATE is defined in f8wConfig.cfg, the same file for which NWK_INDIRECT_MSG_TIMEOUT will determine how long (seconds) a message is held for a sleepy end device before being discarded.

Regards,
Ryan

0 Luca Vetri over 2 years ago in reply to Ryan Brown1

Intellectual 560 points

Thank you Ryan!

Since I flashed the firmware from Github ( Koenkk if memory is right) I don't think I can change NWK_INDIRECT_MSG_TIMEOUT.

Is there any way i can change it via ZTool?

+1 YiKai Chen over 2 years ago in reply to Luca Vetri

Guru 735455 points

No, you cannot change NWK_INDIRECT_MSG_TIMEOUT via ZTool.

Zigbee & Thread

Zigbee & Thread forum

CC2531EMK: AF_DATA_CONFIRM status = 0xF0