Hello,
I have just finished following the guide: https://dev.ti.com/tirex/explore/content/simplelink_academy_cc13xx_cc26xxsdk_6_10_01_00/modules/zigbee/zigbee_03_fundamentals/zigbee_03_fundamentals.html
I want to make a slight alteration to it where instead of sending one signal when BTN-2 of the "coordinator" is pressed, it sends a signal that doesn't end. To do this, I just put the action in a forever loop (shown).
However, after uploading the code to the boards, and pressing the button, I noticed that it only send about 20 signals before crashing and interrupting the connection between the coordinator and the switch. This interruption did not clear after doing a regular reset so I need to do a factory reset every time. What can I change to make sure that the signal is continuously sent and the connection is maintained? Thank you