Other Parts Discussed in Thread: CC2652P, , SIMPLELINK-CC13XX-CC26XX-SDK, SYSCONFIG
Hi,
Iam trying to increase the range of Zigbee Network so i increse Transmit power into 5 but range couldn't extent. please help me to extent the zigbee range.
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi,
Iam trying to increase the range of Zigbee Network so i increse Transmit power into 5 but range couldn't extent. please help me to extent the zigbee range.
Can you elaborate the range you expect? You can use TI RF Range Estimator to estimate radio range first. If you need more rang budget, you should consider using CC2652P, which contains PA and can output unto 20 dam tx power, instead of CC2652R.
I expect the surrounding Range upto 14 meter. I have a Doubt can i access advanced Radio settings and how to anable advanced Radio settings in CCS
It should be no problem to have 14 meters line-of-sight radio coverage. Do you use TI LAUNCHXL-CC26X2R to test this or you use your own custom board?
I use AN2652UA-A Chip and i use our own board, 14 meter not covered in indoor at apartment
Do you have wall or something blocking between the 14 meters space? I don't have experience using AN2652UA-A but you can use SmartRF Studio 7 to do PER test to this module to make sure the RF performance is good first.
Hi Praveen,
If a JTAG connection is available, can you try comparing coverage when using Smart RF Studio 7 in IEEE 802.15.4 mode? Do you have any LaunchPads to test against? Are you able to form/join a Zigbee network at close range? Are you using a ZNP and if so are you building the firmware yourself? What version of SIMPLELINK-CC13XX-CC26XX-SDK is being used and are you using the SYS_SET_TX_POWER MT command?
Regards,
Ryan
In Smart RF lauchpad Cc2652 R not showing, it shows unknown.
Already I build the ZNP Firmware within Transmit power into 5 in the CCS ---> znp.syscfg and i used SIMPLELINK-CC13XX-CC26XX-SDK version as 5.40.
Iam not using SYS_SET_TX_POWER MT command and i don't know where its command used.
You will need a JTAG connection to the CC2652R to establish Smart RF Studio session. Also make sure to fully erase all device memory, including NV memory, before re-programming. Monitor and Test APIs would be used from the host application, which can override the SysConfig settings.
Regards,
Ryan