Other Parts Discussed in Thread: CC2530, Z-STACK, CC2538
Dear netizens,
Hello everyone. When I was using ZNP + HOST, I connected two development boards (cc2530 chips) with ZNP burned on them to two laptops via serial ports respectively. I used the Z-tool software to send commands to them, making one a coordinator and the other a router. The router and coordinator must be within 1 meter to join the network accurately and quickly. When they are 3 meters apart, the router sends nine network joining requests before successfully joining the network. Can anyone tell me if this is due to the chip itself or if there is a part of the code that can be changed to solve this problem? Please feel free to leave a message. Thank you!
Best regards