CC2530 settings for coordinator and end device?

Hi Marco,

when you open IAR Workbench, you just have to choose in upper left corner of IAR which logic type would you like your device to be. So you select Coordinator and then download your code to one ZigBee device,then you select End Device and then download the code to other ZigBee device and that is all.

I am not shure if I understood your question well, hope this is it, and if it is not sorry.

Zivorad

Hi Marco

The info Zivorad refers to can also be found described with screen shots in the Z-Stack user's guide.

If you e.g. install the Z-Stack for the CC2530 you can find it here:

C:\Texas Instruments\ZStack-CC2530-2.2.2-1.3.0\Documents\CC2530\Z-Stack User's Guide - CC2530DB.pdf

I can also recommend reading the developer's guide:

C:\Texas Instruments\ZStack-CC2530-2.2.2-1.3.0\Documents\Z-Stack Developer's Guide.pdf

Good luck!

-LL-

Hello all,

I have a similar problem about the coordinator and would appreciate any help. I did the steps Zivorad mentioned and have coordinator configured. I have chosen two channels for the coordinator to find the best one and make the network for that, the only problem is, I do not know which channel is active now by the coordinator, can it display or show me what channel is selected?

Thank you,

Leila

It does work.

Thanks.