ZDO_LEAVE_IND after ZDO_MGMT_PERMIT_JOIN_REQ

Aksel Bondø

I'm performing a ZDO_MGMT_PERMIT_JOIN_REQ on my coordinator to let my end device join the network, however, emediately after I receive a ZDO_LEAVE_IND with request parameter = FALSE.

Is this what I should expect? What do I do next to let the corrdinator interact with the end device?

over 10 years ago

0 YiKai Chen over 10 years ago

Guru 735455 points

I should be very easy to use ZDO_MGMT_PERMIT_JOIN_REQ. Turn it on and devices can associate with ZC. Would you specify how you use it?

0 Aksel Bondø over 10 years ago in reply to YiKai Chen

Prodigy 100 points

Hi YiKai, I found a solution to my problem.

I had securty disabled in the firmware. As soon as I enabled security I stopped receiving the leave indication and received instead end device announce indication.

Zigbee & Thread

Zigbee & Thread forum

ZDO_LEAVE_IND after ZDO_MGMT_PERMIT_JOIN_REQ