regarding type of packets in Ubiqua protocol anlayser with cc2530dk

Sir,
in my thermostat program how i make the coordinator to enable permit join where it is available in code sir.
I will be so happy if u say where i have to do changes

sir,
i have gone thru and i changed the key in the security option , i got all other type of packets .
but now the channel number is 11 , previously when i set ch no 24 it was sniffed.
bu today i got only by channel no 11. why is it so sir.
why in ch no 24 it is sniffing

Maybe there was other Zigbee device on channel 24 so your sniffer got it when you tested it before.

sir,
thank u sir.
I want to show some output to my superior whatever i am sniffing it is k or else i shld do some changes in my program, if it so where can i get the details what and all i can change in my program and what changes i will get in the sniffed document.

If you intend to change channel, you can change -DDEFAULT_CHANLIST in f8wconfig.cfg.

sir,
where that file is ?
pls dont mistake me sir.

thank u sir.
I want to extend my network whether can i able get the devices cheaper pls refer some which i can attach with my CC2530DK

You can refer to world.taobao.com/.../526442318351.htm

sir,
i will purchase sir.
sir i need to attach real time sensor to my kit
Not sure what is your temperature accuracy. Here is a list that might be interested to you.

1. SPI - LM70, LM71, LM95071, TMP121, TMP122, TMP123, TMP124, TMP124
2. UART - TMP104, TMP107
3. 1-Wire - LMT01 (This might be very difficult to implement, but we do have example firmware in MSP430)
4. ADC - LM20, LM94022, LMT70 (best accuracy), TMP20, and much more


Please tell me sir which sensor i can get to be attached.

What's your question about temperature sensors?

sir,
which temp sensor from above listed can i able to attach with my kit sir, such that it is compatible with my kit.

sir
after attaching sensors what changes i should make in the source code sir. where can i get the sample programs for temperature sensor.

sir,
i am new to embedded programming where can i get the material to study and write my own code

Can you specify which interface you want to use? SPI, UART, or ADC?

Sir ,

I have send the screen shot i said i am using FTDI as my interface.

FTDI as interface? Do you mean you want to use UART?

sir
yes sir. UART .

You can refer to MT_UART.c in SampleLight example.