CC2650MODA: ZNP (Z-Stack) code gets stuck at UART_open

Afzaal Ameer1

Prodigy 140 points

Part Number: CC2650MODA
Other Parts Discussed in Thread: Z-STACK

Hi, I am trying to the run the ZNP project from Z_Stack Home v1.2.2a in IAR v7.80.

The code gets stuck at UART_open in `npi_tl_uart.c`.

UART does work otherwise. Like the uartecho example works. Any pointers to what could be a problem here ?

over 3 years ago

+1 Ryan Brown1 over 3 years ago

TI__Guru**** 202076 points

Hi Afzaal,

MODULE_CC26XX_5X5 will need to replace MODULE_CC26XX_7X7 in the C/C++ Compiler -> Preprocessor -> Defined symbols. You can also review the Z-Stack ZNP Interface Specification and NPI User's Guide as well as relevant E2E posts.

Regards,
Ryan

0 Afzaal Ameer1 over 3 years ago in reply to Ryan Brown1

Prodigy 140 points

Thanks a lot.

Zigbee & Thread

Zigbee & Thread forum

CC2650MODA: ZNP (Z-Stack) code gets stuck at UART_open