CCS/CC2564MODN: how to use hci command in msp430?

youngjun kim

Intellectual 270 points

Part Number: CC2564MODN
Other Parts Discussed in Thread: MSP430F5659, CC2564

Tool/software: Code Composer Studio

hi,

i'm using cc2564modn + msp430f5659 custom board.

i want to change cc2564 mode to edr3.

So, i found cc2564 VS HCI command. → http://processors.wiki.ti.com/index.php/CC256x_VS_HCI_Commands#Command_Packet

over 8 years ago

0 Vihang Parmar over 8 years ago

TI__Mastermind 29311 points

Hi,

For normal BT classic communication, you cannot select to only use 1 out of the supported modulation schemes (GFSK, EDR2 and EDR3). All 3 modulation types must stay enabled. And depending on the negotiation with another BT device on the remote side, the modulation type will be automatically switched. You can find more details about this in the Bluetooth Core Specs.

Best regards,
Vihang

0 youngjun kim over 8 years ago in reply to Vihang Parmar

Intellectual 270 points

Thank you Vihang.

0 youngjun kim over 8 years ago in reply to Vihang Parmar

Intellectual 270 points

Hi vihang.
i have a question.
you said bluetooth modulation is selected by remote side.
Then, how can i select modulation type in remote side?
i try to send 3Mbps data rate in msp430.
But, Data rates are up to 400 kbps maximum.
Thank you.

Bluetooth®︎

Bluetooth forum

CCS/CC2564MODN: how to use hci command in msp430?