LAUNCHXL-CC1310: Srf06EB with a CC13xx launchpad mounted on it

after these steps you referred to should i just start cloning with this command?
git clone --recursive github.com/.../contiki

this showed

thank you so much for answering after i did the steps, i have now to do these steps:

Bulid slip-radio.bin using the following steps.
cd examples/ipv6/slip-radio
make clean
make TARGET=srf06-cc26xx BOARD=srf06/cc13xx slip-radio.bin

when i wrote make clean this showed up, what should i do? this is exactly what happened before and made me do all he steps again

im sorry for asking alot, but this error showed

this is what is inside the slip-radio directory

You should use "git clone --recursive https://github.com/contiki-os/contiki" instead of "git clone --recursive https://github.com/contiki-os/contikii"

thank you so much i did all that successfully, but now for the flashing i already have flashed this file in my launchpad (as im using it as a gateway) eth1310lp-915mhz.bin , and now i want to flash the new bin file along side with it, how can i specify the address of each?  

hello sir,
thank you for answering i follow your steps right away but i just want to understand why i can't follow these steps (to run 6lbr on the gateway): ,
and how can i run cc26xx-web-demo on the other launchpad?

I am confused by you. Can you elaborate what you want to do? Do you mean to run 6lbr on Raspberry Pi, BBB or Linux PC?

hello,
i'm sorry sir to confuse you , my system gateway will run on one of the cc1310 launchpads , and the other launchpad will have the program of my application (which is smart lock). and the communication protocol i want to do between them is 6lowpan,
and what confused me because i was following this link to run the 6lbr on my gateway sunmaysky.blogspot.ae/.../contiki-subg-hz-6lowpan-on-cc1350.html