RTOS/LAUNCHXL-CC2650: Zigbee coordinator cc2650 launchpad

DRY STONE

Part Number: LAUNCHXL-CC2650
Other Parts Discussed in Thread: CC2650, , Z-STACK

Tool/software: TI-RTOS

hello all:

i'm trying to make a zigbee network using cc2650 launchpad, i need help how to make cc2650 launchpad as a zigbee coordinator using ZAP and ZNP architecture.

Thank you

over 8 years ago

0 YiKai Chen over 8 years ago

Guru 735695 points

If you download and install Z-Stack Home 1.2.2a, you can run znp_coordinator_pro_secure_linkkeyjoin.hex (under C:\ti\simplelink\zstack_home_1_02_02a_44539\Projects\zstack\ZAP\ZNP-HexFiles\CC26xx) on your LAUNCHXL-CC2650 to act as coordinator ZNP.

0 DRY STONE over 8 years ago in reply to YiKai Chen

Expert 1060 points

i would like to make communication between two LaunchXL cc2650 to make a sample light switch...could any one explain me how to connect end device to coordinator?

0 YiKai Chen over 8 years ago in reply to DRY STONE

Guru 735695 points

You have to setup coordinator and enable permit join to make end device to join.

0 DRY STONE over 8 years ago in reply to YiKai Chen

Expert 1060 points

is there any tutorial to help me to do this steps??

0 YiKai Chen over 8 years ago in reply to DRY STONE

Guru 735695 points

CC2650 can only run as Zigbee end device under SOC mode due to it is not enough flash. If you want to run it as coordinator, you have to use ZAP-ZNP mode which CC2650 only acts as ZNP. The easiest the way is to use Z-Tool on Windows desktop to act as ZAP and connect LAUNCHXL-CC2650 running ZNP to form Zigbee network. You can refer to sunmaysky.blogspot.tw/.../setup-zigbee-ha-coordinator-with-ti.html for how to setup coordinator using Ztool. For running SampleSwitch end device on LAUNCHXL-CC2650, you can refer to processors.wiki.ti.com/.../CC2650_LaunchPad_User's_Guide_for_ZigBee

Zigbee & Thread

Zigbee & Thread forum

RTOS/LAUNCHXL-CC2650: Zigbee coordinator cc2650 launchpad