CC2650: meshnetworking

Hi,
i am currently working on the cc2650,i am able to send the normal test massage to the three gateways with one node. by using the broadcasting.i am unable to send the RSSI values to the gateways. .can you please suggest me . how cam i send.

I couldn't understand your question well. Can you elaborate?

i need to send the RSSI values to one node to the 3 gateways.

I don't know how one node can send a message to 3 different gateways.

Hi,
i am working on the cc2650, i want to see the received data packets in gateway side.any changes are required in code level.

Hi,
i am currently working on cc2650, is there any posibility to avoid the continous listening mode in side the node side.

I couldn't understand your question well. Please elaborate!

When ever the node continously listening. i need to block some time in node side.

I couldn't understand your description. Can you elaborate?

it is possible to do the broadcasting in side the boarder router code.

Yes, it is possible.

can just guide me, how to do it.

You can try to refer to broadcast-example.c under contiki /examples/ipv6/simple-udp-rpl

thanks i tried these,but i want want to broadcast in side the contiki/examples/ipv6/rpl-border-router/border-router.c

I suppose you can combine broadcast related code in broadcast-example.c into your border-router.c to make it work.

when ever i incude broadcast in side the boarder-router code . these broadcast thread not started.give suggestion for me.

Do you use process_start to start broadcast process?

node to gateway communication,after receiving the packet.first who will collect packet.in code level.

There's receiver code in broadcast-example.c too.

yes

You can do receiving code in the same way.

hi,

Now i am dong node to gateway communication . i need to print the routing table, i tried through the nbr-table.c but i didn't get neighbour table ,Please guide me

how can i get neighbor table ,in code level how can i get ?

I don't have experience doing that. Cannot help.

Hi,
currently i am working on cc2650 . i want to now the working principle of the mesh networking protocol in 6lowpan contiki without the rime stack.can you please suggest me .

I think you can refer to processors.wiki.ti.com/.../Cc26xx_sw_examples

Hi,
currently i am working on cc2650 . i am able to create a mesh network . how can i communicate with leaf node . which code i need to flash inside the leaf node side .
please help me.

Hi,
currently i am working on cc2650 . i am able to create a mesh network . how can i communicate with leaf node . which code i need to flash inside the leaf node side .
please help me.

You can refer to cc26xx-web-demo example in Contiki OS.

HI,
in mesh network all the node are connected together , in the sence it having that route entries. if we need to print that routing table, how can i print that table, is there any code in contiki, please help me.

HI,
in mesh network all the node are connected together , in the sence it having that route entries. if we need to print that routing table, how can i print that table, is there any code in contiki, please help me.

I am not aware of anything to do this. I suggest you to post this request on Contiki GitHub to see if experts there can help you.

Hi,
currently i am working on cc2650 . is there any way to communicate between the two dags. you please suggest me .

You can use RF examples at dev.ti.com/.../ to do it.

HI ,
currently i am working on cc2650 . can you explain the concept of the Auto commissioning in contiki. you please suggest me .

What do you mean " Auto commissioning"?