CC2650: Contiki 6lbr slip radio on sensortag cc2650

You don't have to remove the file extension of Makefile.CC2650.

When I run "make clean" it results in the error
--> make: *** No rule to make target `clean'. Stop.

And when i run "make TARGET=srf06-cc26xx BOARD=sensortag/cc2650 slip-radio.bin" it results in the error
--> make: *** No rule to make target `slip-radio.bin'. Stop.

Thats with the extensions as it is originally.

Couldn't understand your description. Does it work now?

Sorry, I just meant that when i keep the directory as it was when I downloaded it, i.e

/contiki/platform/srf06-cc26xx/sensortag/cc2650

Makefile.cc2650 board.h leds-arch.c

Running the make commands results in the errors previously mentioned. So i m not sure.

Do you know what version of contiki works for you?

Try to do "git submodule update --init " in your contiki folder and do "make TARGET=srf06-cc26xx BOARD=sensortag/cc2650 slip-radio.bin" again.

Unfortunately this didn't work. I tried doing git pull also but still no luck.

Try to remove whole Contiki folder and git to try again. I just test and it works fine.

What directory have you contiki saved in? Also, are you running the "make" commands in the following directory /contiki/platform/srf06-cc26xx/sensortag/cc2650. In addition are you running as root user or user?

This solved my problem :) Thank you so much. I deleted contiki and reinstalled it and used the the directory contiki/examples/ipv6/slip-radio for the slip-radio.bin file. After uploading slip-radio.bin to the cc2650 and connecting the devpack with the cc2650 attached to the raspberry pi, the sensors are finally displayed. (I had previously tried using the cc2531 usb dongle but had problems which i think had something to do with speed or raspbian version as mentioned in the forum github.com/.../92)