• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 2 answers
  • Subscribers 19 subscribers
  • Views 155 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

SN74AVCH4T245: problem solving

Rhea Gao
Expert 2360 points
Part Number: SN74AVCH4T245
Other Parts Discussed in Thread: SN74LVC1G125

Hi，

The customer encountered the following problems in use, please help to solve them.

1. The following SPI interface, one master and two slave, SN74AVCH4T245RSVR output impedance is too high, resulting in the flash output signal cannot be recognized by the MCU.

  • Connect as follows:

2. In the above connection, the waveform tested at 1 is a square wave with a high level of 1.1V and a low level of 0V. The MCU cannot recognize the high level, so the number read out is usually 0;

The following attempts have been made to no avail;

a. Add pull at place 3 (level conversion input) as shown in the figure above, and the received signal waveform at place 1 is a square wave with a high level of 3.3V and a low level of 2.2V.

b. Add pull at 2 as shown in the figure above, and the received signal waveform at 1 is the same as the initial state, that is, the high level is 1.1V, and the low level is 0V square wave;

c. In the figure above, add the pull down at 3, add the pull at 2, and the received signal waveform at 1 is the same as the initial state, that is, the high level is 1.1V, and the low level is 0V square wave;

If you disconnect cable 3, the communication still cannot be normal. Only by disconnecting cable 4, can the MCU and flash communicate normally.

As above, please help answer, thank you!

  • 0
    TI__Mastermind 35775 points

    Hi  Rhea,

    Rhea Gao said:
    2. In the above connection, the waveform tested at 1 is a square wave with a high level of 1.1V and a low level of 0V. The MCU cannot recognize the high level, so the number read out is usually 0;

    What is observed at the output of the AVC device (especially when MISO Flash is disconnected)? I suspect MISO Flash is expecting AVC to receive but it is sending as shown in the diagram. Hence, bus contention, thanks.

    Best Regards,

    Michael.

  • 0
    Guru 291660 points

    The MISO signal has three states, high, low, and disabled. The third state is needed to allow multiple devices to share the signal line.

    Your circuit does not handle the third state; the level shifter will output a signal even when the FPGA has its output disabled.

    You have to insert a three-state buffer like the SN74LVC1G125 after the level shifter's output; you can use that slave's /CS signal to control the buffer.