• State
  • Locked Locked
  • Replies 4 replies
  • Subscribers 30 subscribers
  • Views 267 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSPM0G1107: Flash size issue

Nian Yang
Prodigy 50 points
Part Number: MSPM0G1107

Hi TI experts,

I have a problem about build the binary file.

scenes 1:

if my code size last bit is 0x8, it can execute normally.

scenes 2:

if my code size last bit is 0x0, it will crash at starting execution.

According to my observation, total flash size does not match the ".binit".

But I have no idea how to fix it...

There is my linker command file.

Could you give me some suggestions?

Thanks for your time and response.

BR,
Nian

  • 0
    TI__Genius 16995 points

    Hi Nian,

    Nian Yang said:
    if my code size last bit is 0x0, it will crash at starting execution.

    I think it it has nothing to do with code start loaction. If you want to verify it, then you can set a Flash area start with 0x8 for .bint in cmd file.

    Also, what does the ".bint" used for? I find it do NOT have the same segment in example code. 

    Nian Yang said:
    According to my observation, total flash size does not match the ".binit".

    What does this mean... Sorry I don't get your point.

    B.R.

    Sal

  • 0 in reply to Sal Ye
    Prodigy 50 points

    Hi Sal,

    The attached file is my map file.

    Nian Yang said:
    According to my observation, total flash size does not match the ".binit".

    I mean if ".binit" start at 0x76f8 and length is 0x10, the flash total used should be 0x7708, right?

    But my flash only used 0x7700.

    I could not figure out my setting where is wrong...

    BR,
    Nian

    5611.test.zip

  • 0 in reply to Nian Yang
    TI__Genius 16995 points

    Hi Nian,

    The ".binit" section is used for Boot-Time Copy Tables, which is used for RAM function code.

    Please check the memory address or the disassembly code of abnormal one and whether it is has the correct value. 

    Nian Yang said:
    I could not figure out my setting where is wrong...

    The cmd file is correct, so I assume it might relevant to other factors. What do you change between the normal and abnormal code?

    B.R.

    Sal

  • 0 in reply to Sal Ye
    Prodigy 50 points

    Hi Sal,

    Sal Ye said:
    Please check the memory address or the disassembly code of abnormal one and whether it is has the correct value. 

    Okay, I will check with my code.

    Sal Ye said:
    What do you change between the normal and abnormal code?

    I just add one command to align flash size to 0x8, such as I2C/SPI read command.

    BR,
    Nian