MSPM0L1306: Difference in Standalone SysConfig and CCS included SysConfig

Hi, Mari

You can see your syscfg version here:

The latest version is Version: 1.18.0.3266 Release date: 04 Oct 2023

Mari Tsunoda said:

On the "Reserve Peripherals" tab, there are more peripherals available

Check your version first. Here is the same.

Mari Tsunoda said:

In the standalone ver. it has this board view whereas CCS sysconfig ver. does not have this.

For hardware section and this question, please change the LaunchPad or device by click image button below:

Then click switch button to change LaunchPad or Board-None and Device-L1306.

Regards,

Helic

Hi Helic,

Thanks for your response.

I updated and re-checked everything, but still the same result for me. Do you have any differences between your CCS Sysconfig vs. standalone sysconfig or is this only an issue on my laptop?

Best,

Mari

Hi, 

Here is the same of device L1306:

At sysconfig side, you need try this at start:

At CCS, right click project - properties - general - products:

Besides, we don't usually use reserve peripheral, software is more commonly used.

Regards,

Helic

Hi Helic,

Thanks for the super quick response. I see what you mean now.

Why is it that the ccs sysconfig opens up the 'board unselected' 'mspm0l1306' device for the example codes, when I choose for LP-MSPM0L1306, and not the LP specific sysconfig.

-Mari

Hi Helic,

Also, follow-up question: when should I pick the LP board specific sysconfig? or should I always just pick the board unselected option.

Best regards,

Mari Tsunoda

Hi, 

It has a board view for easier hardware preview.

Actually, both board and device share the same MCU chip L1306.

Mari Tsunoda said:

follow-up question: when should I pick the LP board specific sysconfig? or should I always just pick the board unselected option.

There is no specific requirement to choose between them, because example code all use device selection, so

I usually use device-L306 instead of board LP-L1306.

Regards,

Helic

Hi Helic,

Thanks for your quick response.

Mari Tsunoda said:

In the standalone ver. it has this board view whereas CCS sysconfig ver. does not have this.

I understand this now.

So there is no code generation differences between the board vs device selection then?

Thanks,

Mari

Hi, Mari

Mari Tsunoda said:

So there is no code generation differences between the board vs device selection then?

Why not have a quick test for that?

Compare the file ti_msp_dl_config.x is OK.

A useful software will help you a lot: Scooter Software | Home of Beyond Compare

Regards,

Helic