Dear TI Experts,
for our production we need to trigger a system reset after programming the the keys (SMPK, SMEK).
This is necessary because of our production setup, were we dont' have the possibility to do a power cycle during the procedure.
When doing a "Dry-Run" were VCC is disabled and the keys are not programmed, the follow function works fine and we see a reset as expected:
(void)Sciclient_pmDeviceReset(SystemP_WAIT_FOREVER)
We also tried do do a warm reset via this function, but observe the same results: SOC_generateSwWarmResetMcuDomain()
Is there a possibility to achieve the intended functionality?
My only explanation at the moment is, that by programming the Keys the SOC SW is in a state so it can't accept any commands.
Is it mandatory to do a power cycle after programming the OTP Keys?
Thanks in advance and best regards
Robin
