Tool/software:
Hi
We have chosen Maxlinear's MxL86111 PHy chip. From the datasheet of the PHY chip, we can complete the configuration of the PHY chip through pin strapping, and we do not need to configure the PHY register with MDIO. So, during the initialization process of MCU, how do we complete the initialization of Ethernet? Do we still need some files in the following figure?
Is there a method for converting driver files between two operating systems?
I do not have any straightforward answer for this. But, you can
1. Ask PHY company to provide RTOS driver
2. Compare existing PHY Linux driver and RTOS driver and create for new PHY.
For example:
Below are Linux driver for DP83867/69
and Below are the RTOS version
C:\ti\mcu_plus_sdk_am243x_09_02_01_05\source\networking\enet\core\src\phy
Regards
Ashwani
Hi shaojie ma,
MDIO driver used in MCUSDK is independent of OS.
You can include enet/lib (OS independent) files and then call MDIO IOCTL.
AM243x MCU+ SDK: Enet Management Data I/O (MDIO) (ti.com)
Please take care of MDIO mode you are working Auto mode or MANUAL mode.
AM243x MCU+ SDK: MDIO Manual Mode Enablement (ti.com)
Regards
Ashwani
