TMS320F28377D: Calculating Checksum using command line

May

Part Number: TMS320F28377D
Other Parts Discussed in Thread: UNIFLASH,

Hi,

Customer uses Uniflash program for downloading firmware to TI TMS320F28377D.

Can the customer calculate checksum not using uniflash GUI, but similar way to use standalone command line or does checksum already calculated and compared with checksum that on setting?

According to them, they just want to calculate checksum without opening Uniflash program.

Is there any method to calculate checksum automatically after downloading firmware?

Also if it's possible only add command line to .BAT file?

Regards,
Maynard

over 3 years ago

0 Vamsi Gudivada over 3 years ago

TI__Guru* 87105 points

Maynard,

Yes, checksum can be calculated using command line.

We will provide the details here in a day or two.

Thanks and regards,
Vamsi

+1 Ki over 3 years ago

TI__Guru**** 451311 points

May said:
According to them, they just want to calculate checksum without opening Uniflash program.

You can use the UniFlash CLI:

http://software-dl.ti.com/ccs/esd/uniflash/docs/v5_0/quick_start_guide/uniflash_quick_start_guide.html#command-line-interface

Also see:

https://e2e.ti.com/support/tools/code-composer-studio-group/ccs/f/code-composer-studio-forum/606365/uniflash-command-line-interface---calculate-checksum/2231827#2231827

May said:
Also if it's possible only add command line to .BAT file?

Sure. The UniFlash CLI commands can be executed from a *.bat file.

Thanks

C2000™︎ microcontrollers

C2000 microcontrollers forum

TMS320F28377D: Calculating Checksum using command line