Tool/software:
- Hello,
I am working on implementing torque mode (current control mode) using the TMS320F2800157 microcontroller and a 48V encoder-based mid-drive motor (5 pole pairs). I am modifying the Universal Motor Controller Code to achieve the required torque in BL4 by controlling Id and Iq.
Currently, I can achieve stable torque (21 Nm) up to 2000 RPM, but beyond that, I am encountering a module overcurrent fault. For RPM value such as 2250 RPM (max torque required is 18Nm), I’m setting Id = -30, Iq= 120. As I start applying load, I’m increasing the Iq current gradually. I’ve observed that when the load is applied beyond 5 Nm, the motor is fault stopping due to module over current fault. Iq current was increased upto 150A. Below are the key settings and observations:
- USER_MAX_VS_MAG_PU = 0.75
- USER_MOTOR_MAX_CURRENT = 190A
- DC Bus Voltage = 48V
- PI Gains for Current Control (Kp, Ki) are tuned based on initial testing
- Overcurrent fault occurs as speed increases beyond 2000 RPM
Questions:
- What would be the possible reason for module over current fault and what motor parameters are required to consider to avoid this fault.
- Would increasing
USER_MAX_VS_MAG_PUto 0.8 or 0.85 help avoid overcurrent issues at higher RPMs? - Should I adjust field weakening (Id reference) dynamically beyond 2000 RPM to maintain torque control? Right now I’m decreasing Id reference from -10 to -40, setting Iq reference value between 95-110 A
- Are there other parameters in Universal Motor Controller Code that I should consider modifying to prevent overcurrent faults?
Any insights or suggestion would be of great help.
Best Regards,
Prabhakaran CP.
