• State
  • Locked Locked
  • Replies 3 replies
  • Subscribers 62 subscribers
  • Views 129 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

BQ76952: BQ76952 REG2 voltage ripple

Star Xu
Genius 9645 points
Part Number: BQ76952

Hi

The customer design with BQ76952, after the load is added, the output voltage of REG2 will drop. Only by disconnecting the current sense line, there is no such problem.

The output of REG2 is 5V, which supplies power to the peripheral communication chip, and the drop is about 2V.

Please help check it.

Thanks

Star

  • 0
    TI__Mastermind 23081 points

    Hello Star,

    Please share the full schematic with a better resolution. 

    Regards,
    Jose Couso

  • 0 in reply to Jose Couso
    TI__Genius 9645 points

    Hi Jose

    Attached the schematic.

    Waiting for your reply.

    Thanks

    Star

  • 0 in reply to Star Xu
    TI__Mastermind 23081 points

    Hello Star,

    The BREG, REGIN, REG1/2 connections look ok. Although I do not think this will prevent the issue, a 10M Ohm resistor between BREG and VSS is recommended to avoid leakage current during shutdown mode (we haven't seen this much, but we recommend).

    Star Xu said:
    The customer design with BQ76952, after the load is added, the output voltage of REG2 will drop. Only by disconnecting the current sense line, there is no such problem.

    What do you mean by disconnecting the current sense line? Removing the load? Is PACK- the same as the ground of the IC? I have seen customers use the same reference GND for the sense resistor and IC, and this causes many problems.

    Please share the entire schematic where I can see the PACK- and BAT- connections.

    Regards,
    Jose Couso