TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM62L32, AM62L31: PORz and RTC_PORz slew rate

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts, Usually add RC filter on RESET signal to anti-noise, but the slew rate requirement of RESET signal on AM62x datasheet is quite sharp, on customer board it is about 10V-100V/ms, can it meet AM62x reset requirement…
    • 3 days ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: Enable Display Frame Freeze safety feature in openvx

    Gokul S
    Gokul S
    Part Number: TDA4VH-Q1 Tool/software: DSS includes a hardware-enabled freeze frame checker at each pipeline output and vp output. When enabled, it generates a data signature of pixels from a user define region for each frame. The current frame signature…
    • Answered
    • 3 days ago
    • Processors
    • Processors forum
  • [FAQ] AM62L32, AM62L31 Design Recommendations / Custom board hardware design – Guidelines and E2E query links for custom board designers to refer

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts I see the below status on TI.com for AM62L Can you provide additional inputs on the collaterals to be referred or guidelines to follow during custom board design
    • Answered
    • 3 days ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L - Supported bootmode configurations

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: AM62D-Q1 , AM625 , AM623 , AM620-Q1 Tool/software: Hi TI experts help me understand the supported bootmode configurations for the below family of processors AM625 / AM623 / AM620-Q1 / AM64x / AM243x /…
    • Answered
    • 4 days ago
    • Processors
    • Processors forum
  • [FAQ] AM62L32, AM62L31 Design Recommendations / Custom board hardware design – Queries regarding power architecture including PMIC

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Other Parts Discussed in Thread: TPS65214 Tool/software: Hi TI Experts, I am designing custom board using AM62L. Can you provide your inputs on the supported power architecture when custom board design is configured for RTC mode or…
    • 4 days ago
    • Processors
    • Processors forum
  • [FAQ] AM62P: How to Fix Missing TIFSSTUB to enable Low Power Modes in Linux SDK 10.0/10.1?

    Anshu Madwesh
    Anshu Madwesh
    Part Number: AM62P Tool/software: I've successfully tested low power modes on AM62P using the default images. But I've tried to build my own U-Boot images, but now low power modes are not working. What is the cause and solution to this?
    • Answered
    • 5 days ago
    • Processors
    • Processors forum
  • [FAQ] AM62L32 / AM62L31: Why is MMC1 powered by two different voltage supplies, VDDSHV1 and VDDSHV3 ?

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62L Tool/software: Hi TI Experts, Could you confirm that the voltage domains are correct for the MMC1_SDCD and MMC1_SDWP pins? The datasheet shows both MMC0 and MMC2 as having all member pins bellowing to the same voltage domain. For MMC1…
    • Answered
    • 5 days ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to address the gPTP Sync failure post reset recovery of CPSW in Ethenret Firmware?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Tool/software: After a CPSW reset recovery from ETHFW, gPTP fails to re-establish synchronization, impacting time-sensitive applications.
    • 5 days ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: Building and Booting an UBIFS-based Linux rootfs from OSPI NOR Flash using TI Processor SDK Linux v11.x Yocto Sources

    Andreas Dannenberg
    Andreas Dannenberg
    Part Number: SK-AM64B Other Parts Discussed in Thread: SK-AM62B Tool/software: Overview The TI SK-AM64B EVM has an on-board 64MB-sized OSPI Flash chip that can be used to boot the AM64x device from. The documentation associated with SDK v11.0 contains…
    • 6 days ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L - .alg (ASCII) file for use with Altium tool

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Other Parts Discussed in Thread: SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , SK-AM62A-LP , , AM62L , SK-TDA4VM Tool/software: Hi Board Designers, Refer below query related to availability of ASCII (.alg) file for Altium tool Can you…
    • Answered
    • 8 days ago
    • Processors
    • Processors forum
>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 194037 Discussions
  • Not Answered

    [FAQ] Guideline on the Initial Software Post on E2E 0

    652 views
    0 replies
    Started 4 months ago
    by Bin Liu
  • Answered

    [FAQ] Most common problems encountered when developing camera applications on the AM6x 0

    1958 views
    1 reply
    Latest 8 months ago
    by Jianzhong Xu
  • Answered

    [FAQ] AM6x: Latest FAQs on AM62x, AM62Ax, AM62D-Q1, AM62Px, AM62L, AM64x, AM24x, AM3x, AM4x Sitara devices 0

    6469 views
    1 reply
    Latest over 1 year ago
    by Karan Saxena
  • Not Answered

    AM62A7: Failed when build Image with yocto 0

    41 views
    2 replies
    Latest a few seconds ago
    by meng Ke
  • Not Answered

    TDA4VM: Infinite loop while debugging on CCS, probably due to the use of read() function on a binary file on the DSP C7x 0

    222 views
    14 replies
    Latest 3 minutes ago
    by Sivadeep P R
  • Not Answered

    TDA4VE-Q1: Debug port documentation 0

    46 views
    2 replies
    Latest 14 minutes ago
    by Riccardo Ertolupi
  • Not Answered

    J721EXSOMXEVM: MCU Domain - R5FSS Lockstep Mode Memory 0

    43 views
    2 replies
    Latest 24 minutes ago
    by Arun Belamge
  • Suggested Answer

    AM6442: FreeRTOS interrupt Profiling Example 0

    60 views
    6 replies
    Latest 28 minutes ago
    by Tushar Thakur
  • Not Answered

    SK-AM62P-LP: How to Access R5F_MCU to R5F_WKUP Domain +1

    262 views
    18 replies
    Latest 41 minutes ago
    by veerapandiyan v
  • Not Answered

    AM625: Wakeup from Deep Sleep by timers 0

    69 views
    6 replies
    Latest 46 minutes ago
    by Koichiro Tashiro
  • Not Answered

    AM623: Regarding the issue of controlling the restart of the M core 0

    61 views
    3 replies
    Latest 1 hour ago
    by bu yuying
  • Not Answered

    TDA4AL-Q1: [MCAN] Play CAN msg by TSMaster but no data can be got from canBus0RxQueue and canBus1RxQueue 0

    25 views
    0 replies
    Started 1 hour ago
    by Troy Chen
  • Not Answered

    AM3352: Spurius Can Interrupt 0

    25 views
    1 reply
    Latest 1 hour ago
    by Schuyler Patton
  • Not Answered

    TDA4VM: TDA4VM: the inference result of net.bin file on PC in not consistent with the result on board side. 0

    20 views
    0 replies
    Started 1 hour ago
    by Jin yifan
  • Not Answered

    TDA4VM: UFS error in Uboot 0

    154 views
    9 replies
    Latest 2 hours ago
    by Jay Sun
  • Not Answered

    DRA821U: GPIO output value change/MCSPI config performance 0

    51 views
    2 replies
    Latest 2 hours ago
    by Junbok You
  • Not Answered

    AM6421: DDR Margin test result 0

    12 views
    0 replies
    Started 2 hours ago
    by Zekun Bai
  • Not Answered

    TDA4VM: PINMUX TIMO-IO configuration causes voltage value changes 0

    253 views
    12 replies
    Latest 2 hours ago
    by Jay Sun
  • Suggested Answer

    AM62A3: NorFlash S28HS512T sector erase failed 0

    2807 views
    72 replies
    Latest 2 hours ago
    by Zipeng Liu
  • Answered

    TDA4VM: Some PCIE Questions 0

    427 views
    28 replies
    Latest 2 hours ago
    by Takuma Fujiwara
>