• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 103 subscribers
  • Views 108 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

AM6441: Query on USB interface of AM64x in slave mode

Amey P
Intellectual 320 points
Part Number: AM6441

Tool/software:

Hello Team

I want to use USB in device (slave) mode on AM64x.

If we are going to use AM64x USB in slave mode always, Is it necessary to use Vbus pin on the chip? Should it be connected to VCC coming from USB connector (using voltage divider) or can it be left open?

Note: The SoC will be powered using a separate power supply and not from the USB Host port.

Thanks

Amey

  • 0
    TI__Guru**** 153209 points

    Hello Amey, 

    Thank you for the query.

    When the USB is interfaced as device, USB VBUS is recommended to be connected.

    Recommend following the below section of the data sheet 

    9.2.3 USB VBUS Design Guidelines

    Amey P said:
    If we are going to use AM64x USB in slave mode always, Is it necessary to use Vbus pin on the chip? Should it be connected to VCC coming from USB connector (using voltage divider) or can it be left open?

    It is recommended to connect the VBUS voltage divider to the switch voltage connected to the USB connector.

    Regards,

    Sreenivasa