Tool/software:
Hello TI Experts
TDA4VP42 has 4 port CPSW9G, if i have a requirement to connect a 6 port Ethernet PHY externally, would it be possible?
For e.g. I have a requirement of 4 x 100Base T1, 2 x 1000 Base T1 and i use 4 x PHY to realize this concept, Can I connect the MII of the 4 PHY directly to the SoC?
If not then one of the solution for above problem would be connecting an Ethernet Switch , is there any SW solution for this configuration(i.e connecting more MII to 4 port).
Could you please tell how the 4 x Ethernet Ports is mapped to the Serdes, any pointer to the application note would be helpful. I looked into the TRM , no success
In addition to the above question, i have made one more architecture for the Ethernet Switch. I need to know if this is feasible. I have mentioned the Pin number , Serdes number along with the Ethernet Speed.
.
regards
Ratheesh