TDA4AH-Q1: dual SOC power on question

Ho Scorpio

Prodigy 40 points

Part Number: TDA4AH-Q1
Other Parts Discussed in Thread: TDA4VM

Tool/software:

Hello

We are designing a dual SoCs ADAS system composed by TDA4AH & TDA4VM.

TDA4AH , the main SoC, processes the ADAS system; TDA4VM only processes the data from lidar.

A basic power on step is that MCU controls the total sequence, if the communication between the SoCs connected by ethernet port,

We are worry about that the eth initialize step may failed.

6 days ago

0 Tanmay Patil 6 days ago

TI__Mastermind 28540 points

Hi,

Ho Scorpio said:
We are worry about that the eth initialize step may failed.

Is the worry due to initialisation and auto negotiation sequence of SGMII?

How are the SGMII ports connected? Are they connected MAC2MAC?

Regards,
Tanmay

0 Ho Scorpio 6 days ago in reply to Tanmay Patil

Prodigy 40 points

Is the worry due to initialisation and auto negotiation sequence of SGMII? YES

How are the SGMII ports connected? Directly connection without PHY

Are they connected MAC2MAC? YES

0 Tanmay Patil 6 days ago in reply to Ho Scorpio

TI__Mastermind 28540 points

Hi,

In that case you can use the SGMII in master mode. To change this, apply the following patch : 2072.0001-set-sgmii-mac-as-master.patch

Regards,
Tanmay

0 Ho Scorpio 5 days ago in reply to Tanmay Patil

Prodigy 40 points

Hi Tanmay

1. Should only the main SoC set as MASTER by this patch? The second one(slave) ?

2. Power-on delay time controlled by MCU?

+1 Tanmay Patil 5 days ago in reply to Ho Scorpio

TI__Mastermind 28540 points

Hi,

You can set both of them to "Master" and it is supposed to work. Whichever SoC comes up last will establish the link. The sequence would not be relevant in this case.

Regards,
Tanmay

Processors

Processors forum

TDA4AH-Q1: dual SOC power on question