AM3352: Not able to flash AM3352 by using CCS UniFlash 3.4.1.00012

Sadashiva Kamath

Expert 1165 points

Part Number: AM3352
Other Parts Discussed in Thread: UNIFLASH,

Tool/software:

Hi,

I have installed CCS UniFlash 3.4.1.00012 in Windows 10 laptop.

I have followed the steps mentioned in the following link to flash AM3352 using Ethernet connection -

3.4.2. Flash Tools — Processor SDK Linux for AM335X Documentation

I do not see anything in "Status View" when I clicked "Start Flashing"

Questions -

1. CCS UniFlash 3.4.1.00012 supported in Windows 10 OS?

2. .bin or .out files can be flashed by using CCS UniFlash 3.4.1.00012?

3. If not, How to convert .bin/.out file into needed format?

1 month ago

0 Ki 1 month ago

TI__Guru**** 439471 points

Sadashiva Kamath said:
1. CCS UniFlash 3.4.1.00012 supported in Windows 10 OS?

Yes.

Sadashiva Kamath said:
2. .bin or .out files can be flashed by using CCS UniFlash 3.4.1.00012?

Yes.

Please note that this version of UniFlash is very old and unsupported.

I will bring this thread to the attention of the device experts for any further suggestions.

Thanks

0 Sadashiva Kamath 1 month ago in reply to Ki

Expert 1165 points

Hi,

What I understood was the latest CCS UniFlash software version that can be used for flashing AM3352 is 3.4.1.00012. Newer versions don't support AM3352.

So, I have used latest software version to flash AM3352.

0 Bin Liu 30 days ago in reply to Sadashiva Kamath

TI__Guru*** 147501 points

Hi,

Yes, Uniflash 3.4.1 is the latest version which supports AM335x devices.

Sadashiva Kamath said:
2. .bin or .out files can be flashed by using CCS UniFlash 3.4.1.00012?

The file format is irrelevant to Uniflash, you just need to ensure the binary is in the right format for the flash which the binary is written to.

Sadashiva Kamath said:
I do not see anything in "Status View" when I clicked "Start Flashing"

Please ensure the board is to set to Ethernet boot mode, and Windows 10 Device Manager lists the board as a Ethernet device.

0 Sadashiva Kamath 29 days ago in reply to Bin Liu

Expert 1165 points

Hi,

Thanks for response, this helps!

How to set board to Ethernet boot mode? Is this can be done by configuring boot mode pins of AM3352? Is there any documentation available?

0 Bin Liu 29 days ago in reply to Sadashiva Kamath

TI__Guru*** 147501 points

Yes, the boot mode pins. Please review the AM335x device TRM initialization chapter.

Processors

Processors forum

AM3352: Not able to flash AM3352 by using CCS UniFlash 3.4.1.00012