Other Parts Discussed in Thread: ENERGIA, USB2ANY
I am currently using two BOOSTXL-PGA460's with the default closed-top transducers, and I'm trying to get the BusDemo example sketch to work.
I have tried using the EVM GUI to set the UART addresses (0 and 1), then opened the Energia sketch and uploaded it to one board (it only ever uploads to the board most recently plugged in), and configured the settings through the COM. However, the results are that the programmed board always shows the same distance value (usually 8-9m) and the other board shows repeating zeroes.
I have no doubt that I'm configuring the boards incorrectly, but since I cannot seem to find a way to program both boards simultaneously or even switch the active board in the EVM GUI without removing the other one first, I'm not sure where to go from here. I know that one of the guides says that the EVM GUI should recognize multiple USB2ANY devices, specifically these boards, but I can only get it to recognize one at a time even though the device manager shows both of them.
I have tried various combinations of setup commands, just in case it's something simple that I missed. This includes flashing both boards from the EVM GUI to get a clean start, then assigning UART addresses and clearing the threshold error, then opening Energia and attempting to upload the sketch. I've also used only the Energia COM prompts to set the values for each board, but with the same results. I have also tried many combinations of the two.
Ideally, I would like to use the EEPROM settings that I optimize through the GUI for each board in the BusDemo sketch, but right now I'll settle for learning how to set this up properly using any settings. I'm sure it's something simple I'm missing and/or not understanding.
Any help getting this up and working is very much appreciated.
Thanks in advance!